 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Portland, OR |
| Posts: | 98 |
| Status: |
Offline
|
Attachment: IMG_2840-0002.JPG (Downloaded 36 times)
Last edited on 04-05-2009 03:37 am by Gary Martin JH 15371
| View single post by Gary Martin JH 15371 | |||||||||||||
| Posted: 04-05-2009 03:32 am |
|
||||||||||||
Gary Martin JH 15371
|
I'm checking the valve clearances on the engine I bought from Ron Earp out of the IT race car. The Exhaust ones are all fine. However I have two Intakes that measure out at .04 inch. Can't quite get a .05 in there. The rest of the intakes are all .05, although two of these are a tight .05. Should I be concerned? Should I re-adjust for more like .05 or .06 ? Also do the valve clearances Tighten Up over time as things wear, or loosen up ? Trying to get 15371 on the road this Spring. Thanks. Gary Attachment: IMG_2840-0002.JPG (Downloaded 36 times) Last edited on 04-05-2009 03:37 am by Gary Martin JH 15371 |
||||||||||||
|
| |||||||||||||