 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-23-2005 |
| Location: | Franktown, Colorado USA |
| Posts: | 69 |
| Status: |
Offline
|
I've had this problem a couple of times. The brass plug will only get worse as time goes by. It was a while ago but the last time I battled with the oil drain plug I ended up drilling a hole through the side of the plug and tapping a puch into the hole then using this like a wrench to turn the plug out. Not an elegant solution but effective.
After that, install a new steel plug (Delta has them, probably others as well). When I ordered from Jim at Delta I also got the seals.
Hope this helps a bit,
Lash