View single post by Art DeKneef
 Posted: 10-22-2008 04:17 pm
PM Quote Reply Full Topic
Art DeKneef

 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
 On one of my rebuilds I was able to get some of the bushings out by using the press method. Like others took a while. But there were some that were rather stubborn and didn't want to budge.

So what I did was use a drill bit and drill through the rubber bushing several times going all the way around. After I did this it wasn't too difficult to get the metal bushing out and then get most of the remaining bushinr out. Followed by a wire wheel to clean the inside.

I felt it took about the same amount of time using either method.

Art