View single post by j23mau
 Posted: 04-22-2008 04:08 am
PM Quote Reply Full Topic
j23mau



Joined: 03-13-2005
Location: Monmouth, Illinois USA
Posts: 33
Status: 
Offline
 I got a little carried away on my car and figured "while I was at it" I would put on the 40's I had sitting in the garage without really thinking it through. Problems have ensued.

1. The 2 studs in the center of the block were not used. (Easy for the strombergs removal, but hence the studs are now frozen) after attempts with rust removal products I am stumped about how to get them off or just grind them off since they aren't used with the dell manifold.

2.Upon the inspection, the cold start piston valve is stuck even after soaking it in carb cleaner. How much pressure can I use to remove? From which direction do I attempt to coerce the valve out?

3. There are no visable numbers on the choke. How do I tell the size of the chokes?

4. Should I replace the needle valve just because?

I am sure there will be more questions as I continue but this should keep me busy for a little while.

Thanks
Jeremy Mau
Monmouth, Illinois