View single post by Brett Gibson JH5 20497
 Posted: 08-02-2006 12:10 pm
PM Quote Reply Full Topic
Brett Gibson JH5 20497

 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 Jim, doing the exhaust header is a major PITA, the steering shaft has to come out, and then you need to attempt to reach all the nuts holding it on, and as you can imagine 32 year old nuts trying to get them off without snapping the studs is going to be difficult.

Check the club garage under Engine Performance, Greg did a complete write up on this subject, even with photo's, personally I would wait if you can live with the noise to do the job in combination with something else, clutch what have you, and pull the engine doing it all at once.

Good luck,    Brett.