 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Mesa, Arizona USA |
| Posts: | 344 |
| Status: |
Offline
|
I got lucky with that car concerning the floor pans and such. The front part of the car, not so much. That was one of the parts cars I cannibalized to save what I could.
On one car I had to replace the seat supports on both sides and the driver's side floor pan. Hardest part was drilling out all the spot welds. Making the floor pan wasn't too difficult after making a template from cardboard. Took a while with a lot of test fits to make sure it fit properly.
Fitting different seats usually results in needing to make some modifications. I put seats from a 2013 VW Golf into my car. Used the JH rails. Seat sits a little high after my "modifications". I did get the seat back motors to work so there is some adjustment available.
Art