 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 08-02-2018 |
| Location: | Long Beach, California USA |
| Posts: | 463 |
| Status: |
Offline
|
When I reassembled my dash I don't recall this being a problem it simply went back in the way it came out. Yes, the hole location is rather odd but then it is British. I'm not sure why the original holes don't line up with the bracket holes, is it possible additional holes were drilled by a PO sometime in the past? Was the bracket in place when you disassembled the dash? I had a number of issues while reassembling the dash but that latch wasn't one of them. I'd say if that's your biggest problem then things must be going pretty smoothly.
Just curious where did you get your degree in Ghetto Engineering and is it a B.S. or M.S.?