 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-10-2012 |
| Location: | BROOKHAVEN, Georgia USA |
| Posts: | 656 |
| Status: |
Offline
|
Attachment: J-H clutch lever pin rotation small.jpg (Downloaded 24 times)
| View single post by redracer | |||||||||||||
| Posted: 09-19-2023 02:10 pm |
|
||||||||||||
redracer
|
When installing a new clutch assembly, check the two pins that engage the throw out bearing for signs of wear on the front surface that rubs against the slot in the bearing. Using a chisel/punch/whatever, rotate the two pins about 90 degrees to essentially give you a new surface' If you have to loosen the pins, just tack weld them in the new position. Attachment: J-H clutch lever pin rotation small.jpg (Downloaded 24 times)
|
||||||||||||
|
| |||||||||||||