View single post by discogodfather
 Posted: 11-30-2021 10:00 pm
PM Quote Reply Full Topic
discogodfather



Joined: 09-17-2007
Location: San Francisco, California USA
Posts: 221
Status: 
Offline
 redracer wrote:
Disco: have done many of these bearing replacements. Use a small cut-off wheel(think DREMEL) and cut the retainer at angles until nearly through. A chisel and a small sledge will crack it. You will likely need to do the bearing in the same manner.
I believe even the workshop manual suggests this method.
good luck, bruce

Thanks Bruce, will do. Found the passage in the workshop manual. I will just cut it completely off rather than using the non-existent specialty tools.

Last edited on 11-30-2021 10:01 pm by discogodfather