 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Mesa, Arizona USA |
| Posts: | 340 |
| Status: |
Offline
|
I used a mold release wax that I used earlier to make a couple of pieces for something else. Those pieces popped off with a little effort. That's why I was surprised when I had so much trouble removing the mold pieces. The mold itself turned out OK except for everything sticking to it.
I didn't use any PVA as I didn't think I would need it based on not needing it on the pieces I made before. But I plan on using PVA when I try again. I have all the equipment needed here so that's not an issue.