| View single post by redracer | |||||||||||||
| Posted: 11-02-2020 02:49 pm |
|
||||||||||||
redracer
|
You may want to rig up a colorless line from the block where the plastic tube come out: the threaded side into the engine block plate is 1/8" NPT(27 threads/inch; however, the other side going into the plastic line is 1/8" BSP--28 threads/inch) . Put the colorless tube onto a barbed fitting and run that into some kind of catch tank so you don't make a mess. Also, I would suggest spinning the shaft with a 17mm bolt instead of the 6mm allen hole, as the hole WILL get wallowed out. keep us posted, bruce
|
||||||||||||
|
| |||||||||||||
