View single post by Gary Martin JH 15371

Posted: 10-22-2005 08:30 pm

Joined:	03-12-2005
Location:	Portland, OR
Posts:	98
Status:	Offline

I contacted Jorge by email and asked him about the hard plastic seals. Here is his response.

WE USE THE SAME GASKETS ON THE "SPITFIRE" FUEL TANKS (THEY HAVE THE SAME EXACT SET UP FOR THE FUEL SENDING UNITS), WITHOUT A PROBLEM... I THOUGHT SINCE WE MAKE THE SEALS FOR THAT TANK, I WOULD SEND THEM FOR THE JENSEN'S, WE DON'T MANUFACTURE RUBBER GASKETS... IF YOU CAN GET ONE, IT'S YOUR CHOICE... I OFFER THE TANKS, THE GASKETS I SENT EXTRA, N/C. PLEASE SEND ME PHOTOS ONCE YOU INSTALL THE TANK...

THANX! JORGE CERVERA

So Jorge says they work. However I think I'm going to find a rubber one for the sender unit. I will check JHPS store or Delta. Perhaps we can buy them there. I test fit my sender with my old rubber seal and it's not tight enough. The plastic seal is thicker than the standard rubber seal. So it looks like you would need two rubber gaskets to make a tight fit.

Gary