View single post by DonBurns
 Posted: 04-12-2020 10:16 pm
PM Quote Reply Full Topic
DonBurns

 

Joined: 09-18-2015
Location: Fullerton, California USA
Posts: 149
Status: 
Offline
 I've hit my first snag on installing the LotusBits W58 kit. I'm not seeing how the clutch arm pivot is supposed to attach. If there is someone who remembers doing this, I would appreciate any advice. I am also sending plea for help to Mike at LotusBits. Photo shows pivot with what I assume is the mounting plate as supplied by LotusBis, positioned about where it would need to go. Of course 4-speed pivot has no mounting plate and screws into that single hole. The original is much too long to use, and the new one is too short to screw into the hole if taken off the plate.

Another question - there are two mounting holes from the bellhousing to engine with positioning tubes. The new bellhousing did not come with these, and I don't think the old ones can be removed from the 4-speed bellhousing without damaging them. These are available? They are about 9/16" OD, but likely metric? I'll check with Delta tomorrow, since common the stock bellhousing.


Thanks for any help.

Attachment: Clutch pivot small.jpg (Downloaded 81 times)