 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-10-2012 |
| Location: | BROOKHAVEN, Georgia USA |
| Posts: | 654 |
| Status: |
Offline
|
But if this fails, then the "hacksaw" route will work.
| View single post by redracer | |||||||||||||
| Posted: 03-19-2020 02:21 am |
|
||||||||||||
redracer
|
Yes, I have removed quite a few using the customary acme threaded rod (WD40 and a propane torch if necessary as Tom has described) with the diff. in place. Impacting tools may have a good effect as well if you have the them. But if this fails, then the "hacksaw" route will work.
|
||||||||||||
|
| |||||||||||||