 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-10-2012 |
| Location: | BROOKHAVEN, Georgia USA |
| Posts: | 654 |
| Status: |
Offline
|
| View single post by redracer | |||||||||||||
| Posted: 02-29-2020 02:48 pm |
|
||||||||||||
redracer
|
The O.D of this is larger than the spotted hole(31/64") and will NOT work as it will get "pushed" onto the main surface of the interface. Basically, a smaller one that the ID(I don't have the exact size handy, but will look later) whose ID just fits over the pressure hole will get crushed and still be entirely within the spotted surface and NOT push out onto the main interface
|
||||||||||||
|
| |||||||||||||