 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-10-2012 |
| Location: | BROOKHAVEN, Georgia USA |
| Posts: | 654 |
| Status: |
Offline
|
Hope that helps if you haven't already seen this.
bruce
| View single post by redracer | |||||||||||||
| Posted: 09-25-2019 06:17 pm |
|
||||||||||||
redracer
|
I think this was answered, but the fuses are NOT the same # as printed on the original LUCAS fuses. 35 amp Lucas would be around 17 so I use standard 20 amp fuses. If in fact someone put a 35 amp fuse in(non Lucas) the wire would melt before the fuse blew. Hope that helps if you haven't already seen this. bruce
|
||||||||||||
|
| |||||||||||||