 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 08-02-2018 |
| Location: | Long Beach, California USA |
| Posts: | 458 |
| Status: |
Offline
|
When I examined the float for leaks I did notice the depressions left by the wire attachment but the plastic, while depressed showed no signs of puncture and showed no signs of leakage while sitting on that end in the sun for several hours. So while that's the most likely place to leak I was unable to make it leak, anywhere. It's a mystery.
As far as sealing the hole, just a dab of 5min epoxy and it's good to go. When you ask "did it make the float to heavy?" the epoxy-no, the gas in the float-probably.