johnfalveyross
| Joined: | 08-21-2015 |
| Location: | |
| Posts: | 8 |
| Status: |
Offline
|
|
I made a jumper to connect the white yellow wire from the solenoid to the white slate from the tach and connected that to the +V side of the coil. I also ran a second wire from the tach and connected that to the +V side of the coil as well. I have since read here on the message board that if the coil being used has an internal ballast that the white yellow can be eliminated and the white slate wire can go right to the +V side of the coil. Is that where the second (new) wire from the tach should go as well? I will pull the gauge cluster again to see if the wires are as they should be on that end.
|
