View single post by redracer
 Posted: 01-26-2018 07:27 pm
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 654
Status: 
Offline
 Oakleigh: I assume you are talking about the long flanged "U" shaped channels that run under the center of each floor? (could not find the item in my factory parts book; was not even a picture of it?).
We have made them before and should be fairly simple for any fabrication shop and not very expensive. We have also made the shorter flanged channel that the seats bolt onto, only we used heavier metal(again, fairly simple for a fabrication shop)