little red
|
Peening the bush was pretty easy. I used two needle nose vice grips to hold the upper and lower brackets with the rubber in the middle. One at 12 o'clock and one at 6. With everything held tight and propped against a solid metal rod it was easy to use the ball end of the ball peen hammer against the bush and smack it hard two to three times with a five pound hammer. It came out good. Took about five minutes to set it all up and peen the bush. Don't know if it is necessary but it does hold everything in place for installation. I just did not want any rear end squeaks when the installation was finished.
|
