View single post by Screenplay
 Posted: 01-22-2017 12:05 am
PM Quote Reply Full Topic
Screenplay

 

Joined: 07-12-2013
Location: San Francisco, California USA
Posts: 124
Status: 
Offline
 I just received new rear springs for 18341 and am installing them. I have a question about the steel peened bushing/retainer that holds the mounts and rubber insulator together at the top of these springs. Is it really necessary? The bolt that fastens the spring to the underbody pulls it all together upon tightening, so what is the purpose of the peened bush? I've done this before but it was a real pain and took a long time. I'm wondering if perhaps this peened bush was originally there to facilitate assembly line production. I'd like to do it correctly and will take the time to do it right, but I have to wonder about its necessity.

Clinton