 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 10-01-2016 |
| Location: | Australia |
| Posts: | 77 |
| Status: |
Offline
|
The shoulder that touches the boss on the seal cover can't be enlarged. It presses through the bearing bore from front to rear, so bore-size is as big as it can get.
Heyyy? Not sure we're on the same page here. See pic below.
1) not having sufficient travel to achieve enough tension on a range of belts, and 2) being way too hyper-sensitive.
3) I trust Lotus did their homework on the offset as well so i'm mindfull of that too.
Attachment: 1.jpg (Downloaded 143 times)