View single post by DonBurns
 Posted: 09-21-2015 12:59 am
PM Quote Reply Full Topic
DonBurns

 

Joined: 09-18-2015
Location: Fullerton, California USA
Posts: 149
Status: 
Offline
 I am disassembling the front suspension on 15800 and amd a little confused by what I am seeing. The upper ball joint is not attached to the arm with 4 bolts as in every photo I have seen or the manual. It is riveted on, and the rivets have the appearance of having been manufactured that way - don't rally look like home mechanic rivets. Has anybody else seen this? Or am I looking at it wrong? I guess the solution is to drill out the rivets.

Also - should it be extremely difficult to remove the ball joint bolts from the sub axle? I see peple have a hard time removing the lower ball joint from the suspension arm, but have not seen comments of trouble removing from the stub. (Vertical Link).

Attachment: Ball Joint.jpg (Downloaded 127 times)