 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-16-2014 |
| Location: | |
| Posts: | 200 |
| Status: |
Offline
|
Further investigation of the body lean on my GT has revealed incorrect positioning of the bolt hole in the driver's side chassis rail for the rearmost subframe mounting - it is 1cm higher on that side, which could account for the lean. There is a lot of welding in this area, which I suspect is highly prone to rust. A PO has also installed 6mm shims between the front subframe/chassis mounting blocks and the chassis rail, to try to correct the lean.
If this part of your JH has been welded, it would be worth checking that the bolt hole is in the right place, using the measurements in the chassis alignment diagram.
Best wishes,
Nigel