View single post by Jensenman
 Posted: 03-22-2015 10:51 pm
PM Quote Reply Full Topic
Jensenman

 

Joined: 04-14-2005
Location: Columbia, South Carolina USA
Posts: 156
Status: 
Offline
I did a W58 in my JH5, the first time I drove it with the 3:45 axle I went hunting for a 3:73. Now that it's in the car it feels much better; 1st through 4th are fine for around town and 5th is much better on the Interstate. I did my swap with a bellhousing from LotusBits, I had the stock J-H flywheel redrilled for a Toyota Celica pressure plate. The spigot bearing was not compatible with the Toyota trans so I made a new one out of bronze Oilite. The clutch release mechanism uses the stock J-H clutch cable and a modified J-H release fork which allows use of a Celica release bearing. The shifter for the W58 was too far forward so I cut the stock shift extension in half and lengthened it, then cut the Toyota shift lever off and welded a J-H lever to the remaining stub. The shifter comes out in the center of the stock tunnel opening and doesn't interfere with anything.

Last edited on 03-22-2015 10:53 pm by Jensenman