View single post by redracer
 Posted: 03-01-2014 05:23 pm
PM Quote Reply Full Topic
redracer

 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 654
Status: 
Offline
 Tes--I have done it many times:
Remove distributor; put old rag under opening to catch oil.
Use small pin punch to push split roll pin into the distributor shaft opening. If aluminum spring holder doesn't pop right out, push in with finger or wooden drift a few times to loosen it. Remove this with spring and steel plunger. Shim back of spring(the old 6mm. washers that hold down the cam covers, etc., work fine) to 5-6mm **do NOT go over 6mm**. This will give the higher oil pressure needed for the high revs(rule of thumb: 10psi for each 1000rpm). Use MoS2 for reassembly and new "O" ring for aluminum holder.