View single post by Jensen Healey
 Posted: 09-20-2013 09:19 pm
PM Quote Reply Full Topic
Jensen Healey



Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
 Close! The SJ pistons seem to have a cutout along the side of the valve pockets.
Mine look similar to the stock piston but the valve pockets are .010" shallower. The center area is dished .150" compared to the stock .155" so it's .005" shallower. At tdc the edge is .012" below the liner.
I don't think this is a HC piston. These small differences couldn't add up to much.