View single post by Rob Rawe

Posted: 05-03-2013 01:29 am

Quote

Full Topic

Rob Rawe

Joined:	08-17-2007
Location:
Posts:	19
Status:	Offline

I have purchased a 30mm socket & have machined & ground down it's size so it fits in the recessed hole that the nut holding mounting flange for the drive shaft . also not enough threads exposed to tell if right(clockwise) or left(counter-clockwise) to remove nut.

I'm working under the car raised on jack stands w/ out much room to move, so knowing the correct direction to remove it would be very helpful at this point . because it is tightly secured & does'nt want to budge.

rob rawe