 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 01-03-2012 |
| Location: | Diamond Harbour, New Zealand |
| Posts: | 21 |
| Status: |
Offline
|
Glad I decided to take the bits down to the motor factors!
Last edited on 02-23-2013 05:33 am by sholdowa
| View single post by sholdowa | |||||||||||||
| Posted: 02-23-2013 03:32 am |
|
||||||||||||
sholdowa
|
I ended up using one of those fit all spanners - all teeth and tightens the harder you pull. The manual says 10mm but it's certainly 7/16 AF. Master cylinder is completely different too! It's got 08 646979175 G cast into it. Any idea what it is?? Glad I decided to take the bits down to the motor factors! Last edited on 02-23-2013 05:33 am by sholdowa |
||||||||||||
|
| |||||||||||||