 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 07-09-2005 |
| Location: | Boca Raton, Florida USA |
| Posts: | 11 |
| Status: |
Offline
|
I took the driveshaft to Driveshafts Unlimited in Arnold, MO and they managed to disassemble the joint behind the bearing, press on the new bearing I gave them (which by the way is an Austin Marina support bearing, but identical except for some spot welded on nuts which I just knocked off), and reassemble the driveshaft. I just got it bolted back in the car and it works great -- no more floppy driveshaft!
Don't know if any more bearings are out there, but in case there are, here's the part numbers on the box it came in:
1 X 37H 8019
A3358 A3
BTW -- cost me only $40 for the driveshaft work, so this was a good alternative to replacing with a one piece shaft!
Last edited on 07-24-2005 01:25 am by dlg