| View single post by Brett Gibson JH5 20497 | |||||||||||||
| Posted: 12-08-2011 02:37 pm |
|
||||||||||||
Brett Gibson JH5 20497
|
Ross, I would agree with Mason first place to look would be the cable then take a look at the pedal box where the clutch pedal rotates on, I just checked my spare pedal box because I thought there was a grease fitting on it but not so, I would recommend spraying some lube on the pivot points though, also make sure the cable has a nice easy bend and didn't get miss aligned while you were playing about. Worst case would be if the shifting fork has become dislodged off the pivot ball inside the bell housing then you would need to get under and reposition it, which you can do from the outside without pulling the tranny. How are the Dell's ??? Brett
|
||||||||||||
|
| |||||||||||||
