| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission |
| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission |
| Moderator: Greg Fletcher | Page:   1 2 3 4 5 6 7 ...   |
 |
All Topics |  |
 |
Selected |  |
|
Popular | |
|
Recent | |
|
Mark Forum Read | |
 |
New Topic |  |
| Engine & Transmission - Jensen Healey & Jensen GT Tech - | ||||||
| Topic | Rating | Replies | Views | Started by | Last Post  |
|
|---|---|---|---|---|---|---|
 |
Hydraulic clutch conversion Cable to hydraulic |
2 | 4,236 | jomac | 02-22-2023 10:28 pm by Darth V8R |
|
|
2.2 conrods 2.0 vs 2.2 difference in connecting rods? |
2 | 2,002 | rederic48 | 01-13-2023 07:30 am by rederic48 |
|
|
 Need to change out the Timing Belt Tensioner Page: 1 2 |
23 | 41,012 | cjwilson | 10-11-2022 12:52 pm by redracer |
|
|
Oil pan gasket or seal replacement Replacement |
10 | 7,102 | jomac | 09-25-2022 11:20 pm by jomac |
|
|
Belt tensioner bearings DO NOT USE HBC BEARINGS |
2 | 2,365 | redracer | 09-02-2022 07:58 pm by redracer |
|
|
Engine pisotns or liners |
2 | 2,891 | H Puck | 06-19-2022 01:51 am by CDA951 |
|
|
Frequency Range/Measurement for Warned Up Blue Timing Belts? |
2 | 2,679 | WhatsUpDOHC | 05-22-2022 01:47 am by Esprit2 |
|
|
High Torque Starter and Early MkI Clocking/Fit |
6 | 4,145 | WhatsUpDOHC | 04-17-2022 03:12 am by dwalls1 |
|
|
Early MkI Cam Belt Tensioner Adjustment Tool Substitute |
2 | 2,908 | WhatsUpDOHC | 04-01-2022 12:32 am by WhatsUpDOHC |
|
|
Burn Baby Burn Page: 1 2 Disco Inferno |
20 | 32,193 | Joel | 03-09-2022 02:27 pm by noomg |
|
|
sunbeam gearbox gearbox |
8 | 16,272 | patrick lovering | 02-28-2022 10:28 pm by Spaceman |
|
|
4 speed rebuild parts |
3 | 9,774 | Frank Schwartz | 02-28-2022 10:23 pm by Spaceman |
|
|
Pulley & Cam Belt Correct? |
6 | 4,308 | Olddog12 | 01-02-2022 03:06 pm by redracer |
|
|
Leak down and compression testing Good seal to head |
2 | 3,611 | DonBurns | 11-22-2021 08:12 pm by DonBurns |
|
|
Head removal? How difficult? Any gottchas? |
19 | 17,116 | jensendriver123 | 11-17-2021 10:14 pm by Esprit2 |
|
|
Piston compression cold Non starter after decoke and inlet valve change |
8 | 5,701 | rederic48 | 10-30-2021 03:01 pm by rederic48 |
|
|
engine swaps Page: 1 2 shame or fame ? |
35 | 78,984 | roverman | 10-21-2021 08:59 pm by roverman |
|
|
fan bolt size |
3 | 3,364 | Jim McDonald | 10-15-2021 04:14 pm by redracer |
|
|
Valve Shimming Sheet |
0 | 1,979 | redracer | 09-19-2021 09:44 pm by redracer |
|
|
Rear oil seal removal Need to replace rear oil seal |
5 | 4,945 | chuckcm14 | 06-14-2021 01:35 pm by chuckcm14 |
|
|
2.2L Stroker Crank Install, What's Involved? |
7 | 6,589 | noomg | 06-05-2021 04:24 pm by noomg |
|
|
How do I ... ... get the dang shims out? |
0 | 2,153 | subwoofer | 05-26-2021 08:14 pm by subwoofer |
|
|
Strange Misfire |
10 | 7,803 | BrandonDN | 05-10-2021 02:31 am by Tom Bradley |
|
|
907 Head freeze plug sizes |
2 | 3,501 | Max_dvdt | 03-19-2021 05:18 am by Max_dvdt |
|
|
TIMING BELT UPDATE 1986 NISSAN MAXIMA 3.0L V6 |
3 | 4,658 | redracer | 02-25-2021 09:28 am by discogodfather |
|
|
carbon cannister |
1 | 2,862 | 74beans | 02-22-2021 10:10 pm by redracer |
|
|
Strange rattle sound when idling |
11 | 9,344 | Art DeKneef | 01-04-2021 12:45 am by Art DeKneef |
|
|
Engine removal Suggestions on how to remove the engine |
6 | 6,199 | jensendriver123 | 12-04-2020 03:12 pm by jensendriver123 |
|
|
Where do I lift the engine from? |
7 | 16,316 | dschiri1 | 12-04-2020 02:14 pm by noomg |
|
|
Getrag 5 speed sometimes grinds when shifting into first at full stop |
1 | 2,980 | Jagwire64 | 12-04-2020 02:42 am by discogodfather |
|
|
Living the dream: JH W58 5spd Page: 1 2 3 Finally have good transmission installed |
40 | 71,697 | StevenD57 | 11-23-2020 11:25 pm by jensendriver123 |
|
|
Oil pump rebuild Page: 1 2 3 4 complete loss of oil pressure |
 |
68 | 97,052 | terryhowarth | 11-10-2020 10:47 pm by discogodfather |
|
driveshaft 5 speed unusual noise when rotating driveshaft |
10 | 8,231 | jomac | 11-10-2020 02:28 pm by redracer |
|
|
Anyone ever had to retrieve a nut that fell into the cam tower oil return passage? |
7 | 7,346 | jensendriver123 | 09-17-2020 12:24 am by jensendriver123 |
|
|
Starter Motor? or solenoid |
14 | 24,762 | SpeedyMitch | 08-30-2020 04:05 pm by redracer |
|
|
Engine Damper / Shock Upper Mount |
3 | 4,209 | discogodfather | 08-24-2020 04:49 pm by discogodfather |
|
|
Help identifying cam pulleys |
3 | 4,259 | Jagwire64 | 08-14-2020 04:56 pm by Jagwire64 |
|
|
2.4 liter 910 build Update on head work so far |
8 | 8,154 | Max_dvdt | 08-03-2020 08:18 am by discogodfather |
|
|
four speed tranny top cover issue need a fix for loose top cover |
3 | 4,669 | Ralph H | 07-07-2020 01:18 pm by Dakota123 |
|
|
Supra conversions |
 |
7 | 20,204 | jdenglish | 06-28-2020 01:47 pm by Dakota123 |
 Current time is 05:21 pm |
|
Page: 1 2 3 4 5 6 7 ... |
||||
| > Jensen Healey & Jensen GT Tech > Engine & Transmission | Top | |||||
